Home of the BrewNosers

Hi All

I need the assistance of an electrical engineer to help with a project. It's not big, but it would help me greatly to get someone else to look at it for me. Just a personal project that I'm tackling with a controller I'm building. Shouldn't take more than a few minutes and I can repay you in beer. Any takers?

Thanks

just plug the razzamatazz into the discombobulator

bluenose wrote:just plug the razzamatazz into the discombobulator

It's the discombobulation I'm trying to avoid!

EverwoodAveBrewShop wrote:

bluenose wrote:just plug the razzamatazz into the discombobulator

It's the discombobulation I'm trying to avoid!

Ohhhh, in that case, use a jumper cable to connect the flim flam to the whirlymagig

bluenose wrote:

EverwoodAveBrewShop wrote:

bluenose wrote:just plug the razzamatazz into the discombobulator

It's the discombobulation I'm trying to avoid!

Ohhhh, in that case, use a jumper cable to connect the flim flam to the whirlymagig

none of this is helpful...

Not helpful but sure made me laugh out loud.

Are you talking about a motor control, or a PID type control?

mr x wrote:Are you talking about a motor control, or a PID type control?

PID, I'm reworking my control panel and finding conflicting options online (if I didn't I'd be surprised). Anyway, I've got someone on it.

EverwoodAveBrewShop wrote:

mr x wrote:Are you talking about a motor control, or a PID type control?

PID, I'm reworking my control panel and finding conflicting options online (if I didn't I'd be surprised). Anyway, I've got someone on it.

That's right!