SOLD: Stainless Coil
Posted: Fri Apr 10, 2015 3:59 pm
Selling the medium-size coil that Jimmy posted back in December.
5/16" OD, 3/16" ID, 75' or so.
I did use it for a batch this past weekend and performance was really good from an efficiency standpoint: it only took one 6 gallong bucket of water (with a fair amount of snow in it) to chill 4+ gallons of wort to pitching temps. Might have been a touch slower than my 3/8" copper unit, but that could have been the elevations I had the three vessels at.
I'm selling it because it doesn't fit terribly well in my pot (Everwood 15gal) with the side pickup tube installed and since I don't have the capacity to whirlpool right now the square profile makes it a bit of a pain to stir. I think it would be best deployed permanently mounted through the walls of the pot (which would be fairly easy to do given the smaller diameter of the input and output). But that's not consistent with other plans I have so I'm not going to do that myself.
It would likely also make a really good jockeybox coil.
I'm in the Halifax area and can most likely deliver, within reason. I'd like to get the same $50 I paid for it.
The square is 7 3/4" to a side (8" to the outsides of the clips). Height of the coils is 12". Height of the input/output is 15".
5/16" OD, 3/16" ID, 75' or so.
I did use it for a batch this past weekend and performance was really good from an efficiency standpoint: it only took one 6 gallong bucket of water (with a fair amount of snow in it) to chill 4+ gallons of wort to pitching temps. Might have been a touch slower than my 3/8" copper unit, but that could have been the elevations I had the three vessels at.
I'm selling it because it doesn't fit terribly well in my pot (Everwood 15gal) with the side pickup tube installed and since I don't have the capacity to whirlpool right now the square profile makes it a bit of a pain to stir. I think it would be best deployed permanently mounted through the walls of the pot (which would be fairly easy to do given the smaller diameter of the input and output). But that's not consistent with other plans I have so I'm not going to do that myself.
It would likely also make a really good jockeybox coil.
I'm in the Halifax area and can most likely deliver, within reason. I'd like to get the same $50 I paid for it.
The square is 7 3/4" to a side (8" to the outsides of the clips). Height of the coils is 12". Height of the input/output is 15".
