Home of the BrewNosers

Hi all, I'm on the lookout for two 3/8" MPT to 1/4" MFL adapters for my hop randall. Either stainless or brass. Home Depot has a lot of fittings like this but not this one. Any leads? I don't think I've seen flare fittings at Crane either.

We got a lot of stuff from ttl supply in burnside

You can have my Randall if you want it. Probably more fun to make your own though.

http://www.brewnosers.org/forums/viewto ... =25#p67186" onclick="window.open(this.href);return false;

GuingesRock wrote:You can have my Randall if you want it. Probably more fun to make your own though.

http://www.brewnosers.org/forums/viewto ... =25#p67186" onclick="window.open(this.href);return false;

Thanks for the offer but I did make one.

I'm just changing up the fittings so I can swap it out easier using flare / barb swivel adapters on the lines.

On a related note, fresh pineapple on sale for 97 cents each at Gateway meats in Dartmouth. Going to put the APA through it this weekend probably.

AllanMar wrote:We got a lot of stuff from ttl supply in burnside

Hmm, I might have to drop in there again but the last time I left empty handed.

what is MFL?

Male Flared Fitting

http://www.midwestsupplies.com/1-4-mfl-to-1-4-mfl.html" onclick="window.open(this.href);return false;

Those are used a lot for hydraulics and HVAC, might find some around the city. I'll ask our HVAC guy tomorrow. Keep in mind, those fittings come with different angle on the flare.

chalmers wrote:Male Flared Fitting

http://www.midwestsupplies.com/1-4-mfl-to-1-4-mfl.html" onclick="window.open(this.href);return false;

I happen to have one of those to connect my lines when I remove the randall from the system. I'm actually using it on my Hefeweizen with now for a super long line serving at high pressure to keep the CO2 volumes up.

The beer flare fittings are usually 37deg from what I recall. How many do you need, i'll have a look around.

Just two.

Sent from the brew timer.

Check out Parsons Hydraulics.