- Ss Brewtech 10 Gallon Kettle with three 7/8” weldless ports, pickup tube & trub dam
- Two Ss Brewtech 3-piece ball FPT valves
- Ss Brewtech whirlpool fitting and weldless bulkhead
- Spares: trub dam blade and 4 x trub dam o-rings, 2 x PTFE fitting washers, 2 x silicone fitting o-rings, 1 x 7/8” port plug with PTFE washer and silicone o-ring
The kettle was purchased in October of 2016, so it’s got about 3 years and somewhere between 30 and 35 5-gallon batches on it. It’s got a tri-clad bottom so it could be used on propane (what I did) or stovetop (including induction).
I took some time this week to tear it down and give everything a good cleaning, including fully dismantling the ball valves. One of the ball valves has a little bit of distortion on the PTFE seats on either side of the ball, but it still holds liquid at any temperature (replacements are also available). I’ve left it disassembled for buyer inspection but am happy to help reassemble it.
I’m hoping to get $200. I’ll post pictures shortly.