BIAB Aluminum Turkey fryer set. Has weldless stainless steel spigot and 1/2" stainless steel nipple
Great for BIAB brewing with the inner basket, just lift your grains out when your mash is done.
Burner has never been used, haven't had time to put it together.
Moving to a smaller place and will have to down size equipment. Great for 5 and 6 gallon batches.
$80
9 gallon aluminum turkey fryer Biab * new price
-
- Registered User
- Posts: 12
- Joined: Wed Jan 27, 2016 12:24 pm
- Name: Matt Reed
9 gallon aluminum turkey fryer Biab * new price
You do not have the required permissions to view the files attached to this post.
Last edited by msr53 on Fri May 05, 2017 11:01 pm, edited 1 time in total.
-
- Verified User
- Posts: 246
- Joined: Tue Jul 08, 2014 9:13 pm
- Name: Mark Bowser
- Location: Truro
Re: 9 gallon aluminum turkey fryer Biab
I have this same setup at home without the spout. If you don't kind me asking how you drilled the hole for the spout?
-
- Registered User
- Posts: 12
- Joined: Wed Jan 27, 2016 12:24 pm
- Name: Matt Reed
Re: 9 gallon aluminum turkey fryer Biab
It's pretty easy. I started with a small drill bit for a pilot hole, 1/8" or 1/4", then I used a step bit from Crappy tire. My step bit is slightly too small to fit the 1/2" nipple, so I need to use a rounded file to make the hole a little bigger. And when drilling I used some cooking oil to keep the temperature down and prevent the drill bit from grabbing.
If u need help and are in the city I can help Ya out
If u need help and are in the city I can help Ya out
-
- Registered User
- Posts: 1
- Joined: Thu Apr 27, 2017 11:53 am
- Name: Ray Coolidge
Re: 9 gallon aluminum turkey fryer Biab
Nice is it still for sale?
Last edited by Coolidge on Thu Oct 21, 2021 11:55 am, edited 3 times in total.
-
- Registered User
- Posts: 12
- Joined: Wed Jan 27, 2016 12:24 pm
- Name: Matt Reed
Re: 9 gallon aluminum turkey fryer Biab
Yes it is
-
- Registered User
- Posts: 1
- Joined: Mon Jun 24, 2019 9:20 am
- Name: Thomas
Re: 9 gallon aluminum turkey fryer Biab
I will try this way this is quite easy to use. Thanks for sharingmsr53 wrote: ↑Sat Apr 29, 2017 5:49 pmIt's pretty easy. I started with a small drill bit for a pilot hole, 1/8" or 1/4", then I used a step bit from Crappy tire. My step bit is slightly too small to fit the 1/2" nipple, so I need to use a rounded file to make the hole a little bigger. And when drilling I used some cooking oil to keep the temperature down and prevent the drill bit from grabbing.
If u need help and are in the city I can help Ya out
Who is online
Users browsing this forum: No registered users and 36 guests