Home of the BrewNosers

Does anyone have a 3/4" punch I could borrow? I'll be at the grain pick up tomorrow if someone is going there has one?

I read "Metal Punch" and was expecting a recipe

Me too, lol. Let me look around. Can you get it back to me sunday?

I'll bring the drill I used the night you were over. It worked great.

Sandy

LiverDance wrote:Does anyone have a 3/4" punch I could borrow? I'll be at the grain pick up tomorrow if someone is going there has one?

Will a 3/4" step bit work? You can borrow that if you want it.

Well now I have to make a beer called Metal Punch I've got a step bit but really want to make sure this whole is as clean as possible for the element in my OBK kettle. X is can get is back to you on sunday for sure, as long as you're not in NG

Turns out ours is being used. Sorry.

Sent from my Nexus S using Tapatalk 2

LiverDance wrote:Well now I have to make a beer called Metal Punch I've got a step bit but really want to make sure this whole is as clean as possible for the element in my OBK kettle. X is can get is back to you on sunday for sure, as long as you're not in NG

Your element is 3/4"??

RubberToe wrote:

LiverDance wrote:Well now I have to make a beer called Metal Punch I've got a step bit but really want to make sure this whole is as clean as possible for the element in my OBK kettle. X is can get is back to you on sunday for sure, as long as you're not in NG

Your element is 3/4"??

Yes sir it is. No problem X, thanks for trying. Anyone else got one?

Similar to this with a 3/4" swage loc fitting on it.