Help - Ball Valve problem
Posted: Fri Feb 12, 2021 2:39 pm
Good afternoon all;
I am not very good with tools, so I need a bit of help.
I have a brass Ball Valve hooked up to my CO2 tank. Until yesterday it was working fine. Now when I shut it off it is still allowing a bit of CO2 out. If I move the handle forward ever so slightly it then fully closes. From what I've googled I think it is the handle over rotating. Unfortunately I have been able to find a video on how to fix it.
Any suggestions or instructions are very much appreciated.
Thanks
I am not very good with tools, so I need a bit of help.
I have a brass Ball Valve hooked up to my CO2 tank. Until yesterday it was working fine. Now when I shut it off it is still allowing a bit of CO2 out. If I move the handle forward ever so slightly it then fully closes. From what I've googled I think it is the handle over rotating. Unfortunately I have been able to find a video on how to fix it.
Any suggestions or instructions are very much appreciated.
Thanks