Page 1 of 1
SSbrewtech 1.5” TC Bulkhead Compression fitting
Posted: Fri Jul 10, 2020 12:33 pm
by oceanic_brew
Does anyone have one of these? I’m just looking for some measurements on it to see the maximum sidewall I could use these on.
Thanks!
Sent from my iPhone using Tapatalk
Re: SSbrewtech 1.5” TC Bulkhead Compression fitting
Posted: Sat Jul 11, 2020 9:09 am
by EastCoastHoppers
I don't have any of these in stock myself so I wasn't able to do any measuring for you but I did reach out to one of my contacts at SS Brewtech and asked them this. Here is their reply:
"For these compression bulkheads they need a fairly thin surface to work off of, typically 5mm or less. Our Fermenters/kettles that these were designed for are about 1mm-1.5mm thick depending on the model."
Hope that helps!
Cheers,
Matt
Re: SSbrewtech 1.5” TC Bulkhead Compression fitting
Posted: Sat Jul 11, 2020 12:59 pm
by oceanic_brew
Thanks! I reached to them too but they said they weren’t near them to actually measure what they were capable of. I have one that’s for a similar size but it actually unscrews quite a bit