Flex hose for propane burner

[Jimmy]

I am just trying to figure out what type of line would go from the propane manifold to the actual burners on a brewing stand. I am guessing you would have a 3/8" male orifice from the back of the burner and a needle valve on the manifold. Would you use a 3/8" orifice on the valve too and connect one of these flex lines between the 2 orifices?

http://www.ebay.ca/itm/Propane-Natural- ... 500wt_1054

hose.jpg

[mr x]

I've never done gas fitting, but 2 orifices doesn't sound right....

[Jimmy]

For some reason I am having a hard time figuring this out. I am almost at the point where I just want to add a HP regulator to each burner

[Keggermeister]

I have seen low priced propane hoses with regulators/orifices at Princess Auto in the surplus section.

[Jimmy]

For future reference..

Fairview Fittings in Burnside will make up any length propane flex hose with whatever type fitting you need on the ends. I got them to make me some for my stand, 2' long, and they were $10 each.

[mr x]

...I mean sweet.

[chalmers]

Yet another reason why those guys are THE place to go for strange and unusual fittings and materials!